Full Description

1.1These test methods cover the evaluation of fastener use with as manufactured plastic lumber and shapes through the use of two different testing procedures.

1.2The test methods appear in the following order:

		Sections
	Test Method A-Nail, Staple, or Screw Withdrawal Test	4 to 13
	Test Method B-Lateral Nail, Staple, or Screw Resistance Test	14 to 22

1.3Plastic lumber and plastic shapes are currently made predominately from recycled plastics. However, these test methods would also be applicable to similar manufactured plastic products made from virgin resins where the product is non-homogeneous in the cross-section.

1.4The values stated in inch-pound units are to be regarded as standard. The SI units given in parentheses are for information only.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1:There is no known ISO equivalent to this standard.

Product Details

Published: 06/01/2016 Number of Pages: 9File Size: 1 file , 150 KBRedline File Size:2files, 370 KB